ATTACHING A BEARD

Work preferably work on a dry base. First degrease and clean the skin you are going to be working on with Grimas Cleansing Lotion. Then dry the skin with a tissue.
With aid of the applicator brush you spread Water-soluble Mastix over the skin area where something is to be glued on.
Absolutely do not use near or above the eyes.
Close the packaging properly after use. Apply glue to the part of the skin concerned and press the cut surface/obliquely cut side into the adhesive. Work piece by piece.
Please Note: keep the cut section well together during the process of sticking it on to maintain a full beard, also after modelling.

CLEANSING LOTION = Cleansing Lotion
MASTIX WATERSOLUBLE = Mastix Watersoluble
You colour the eyebrows with Water Make-up (Pure).
Water Make-up works just like watercolour paint. Use the brush and a little water to soften the make-up and make it a bit pasty. Test the colour intensity on the hand. Don't work too dry, but do not use too much water.
With Water Make-up (Pure) you colour the cheeks and the nose.
REMOVING THE PRODUCTS

If you have worked with Grimas Mastix Watersoluble, you can remove the Wool Crepe with lukewarm water and a little soap if necessary.
You can cleanse the skin with water and soap (shampoo can also be used). Massage it in briefly and rinse off with lukewarm water. Scrubbing too much with water and soap or shampoo can irritate the skin. You can clean the skin further if required with a cleansing milk or cleansing cream. Massage it in gently and remove it with a soft tissue.

Do not use Afschmink, as this contains waxes and oils which actually adhere the Water Make-up to the skin.
Do not use ready-to-use cleansing cloths. Cleanse the skin further with Cleansing Lotion if necessary.
If the skin feels dry after cleaning, you can apply a care cream.