Grimas | Quasimodo

If the non-shaded parts are lightened, this will enhance the effect of bringing those areas "forward". The shading and lightening must blend into the basic colour in a natural way. If necessary, blur the segments and lines that are to be faded using a dry make-up sponge. You do this with a dabbing action, without wiping.

You powder the face off with Grimas Transparent Powder, Fixing Powder or Make-up Powder. Apply the powder on top of the make-up. You can do this with a Make-up Sponge or a Velour Powder Puff. Allow to settle in and remove excess powder with a Powder-Rouge Brush.

= Transparent Powder

FIXING POWDER = Fixing Powder

MAKE-UP POWDER = Make-up Powder

MAKE-UP SPONGES (DISPOSABLE) = Make-up Sponges (disposable)

VELOUR POWDER PUFF = Velour Powder Puff

BRUSHES POWDER ROUGE = Brushes Powder/Rouge

REMOVING THE PRODUCTS

Wool Crepe that has been stuck on with Mastix Extra you remove with Mastix Remover. You can then already pull some of the hairs loose and remove them with a tissue. The remaining hairs and the adhesive you remove with a cotton wool pad and Mastix Remover. Dab it carefully onto the skin and roll the residual material off the skin.

Removing a latex application: wipe a cotton bud soaked in Grimas Mastix Remover along the adhesive edge to loosen it. Remove the adhesive and make-up residues from the latex prostetic with Mastix Remover.

Massage Grimas Multi Remover Pure or Cleansing Cream into the skin and remove with a tissue. Cleanse the skin afterwards with cleansing lotion.

CLEARING UP THE MATERIALS

Store the make-up in a dry and cool place until the next time you use it.

The sponges are disposable so you can throw them away after use. If you do want to reuse them, first rinse them under the tap with some soap or shampoo or wash them in the washing machine (in a net bag or pillow case), set to at least 60°C.

You can clean brushes with water and soap or shampoo. Put the moist hairs of the brushes back into shape by hand after washing. Dry the brushes lying flat on a towel and do not place them upright, since that causes the moisture to run down into the shaft.

Clean the latex prostetic afterwards using water and soap, and powder it with Grimas Transparent Powder after drying (with a dryer, if necessary). Keep in a dark place.

PRODUCTS