Set out ready for use:
Water bowls
Towel / cape
Cotton buds
Cotton wool pads
Tissues
Scissors
Comb
Hairspray
Razor/clippers
Old pantyhose (for long hair)
Acetone
Before starting, you ensure your hands and nails are well cleaned. File your nails if necessary, so that there are no snags. By doing this you prevent damages on the face and risk of infection.
Always work using clean materials (sponges, brushes, spatulas, water bowls) and change the water regularly.
Get the subject to put on any clothes beforehand that have to be put on over the head. Protect your models clothing with a hairdressing cape or a towel.
To keep the hair together, use a cut panty hose (upper leg part).
To keep the hair together, use a cut panty hose (upper leg part).
To keep the hair together, use a cut panty hose (upper leg part).
Note: do not use hair pins or combs, as they may damage the Bald Cap.
Note: do not use gel.
Grimas Bald Cap is a single-use, transparent, elastic plastic bald cap for use in film, TV and theatre.
Ball both hands into fists and put them into the Bald Cap, stretching it a little so that you can check it.
Fold the front edge back and apply an adhesive edge of about 2 cm just below the hairline with Grimas Mastix Extra. For a natural effect, you follow a possible natural line in the forehead.
Let the adhesive edge go as far as the temples.
Mark out the ears.
A felt-tip pen was used in this example for the sake of clarity. If a Grimas Make-up Pencil for example in a skin tone is used, the result is more subtle and no longer visible later on.
When you finish off the edges with acetone you are also immediately removing the sketch made using the Make-up Pencil.
You should proceed as follows:
Pull the Bald Cap down at an angle to tense it. Dip a cotton bud in acetone (don't work too wet) and melt a small hole in the Bald Cap at precisely the right place: 2 mm below the point where the top of the pinna (the 'shell' of the ear) leaves the head.
Hint: if necessary, you can melt multiple holes along the line for easy cutting.
Get the ears out from underneath the Bald Cap.
Get the model that will wear the Bald Cap to sit up straight. Now make a glued edge of approximately 2 cm along the sideburns. Let this adhesive edge fit up exactly against the glued edge on the forehead. There must not be a gap between them.
Use the same principle: fold back, apply adhesive, reposition the side edge, press gently and fold back again. Allow to dry for about 15 seconds and then apply along the sideburns again.
Apply a glued edge of approximately 2 cm along the hairline of the neck as far as about half-way behind the ears.
Fold it open again, allow to dry for 15 seconds and then close the Bald Cap for the last time.
Note: you finish the edges using cotton buds with acetone. You need 15 to 20 cotton buds for this, because the acetone dissolves the plastic. Don't dip used cotton buds back in the acetone.
Note: do a little piece at a time, and stay in the middle of the adhesive edge so that you are following the shape of the adhesive edge.
Make a small hole at the middle of the adhesive edge at the back as well; cut up to it and then proceed in the same fashion from the back of the head towards the back of the ears.
You colour the Bald Cap with Grimas Camouflage Make-up Pure or with the intense Crème Make-up Pure colours. Note: don't use Crème Make-up Pure for skin tones, but use Grimas Camouflage Make-up Pure.
Take the Camouflage Make-up out with a clean spatula. Rubbing it with your fingertip will make it softer and easier to handle.
Apply the make-up using a sponge.
Merge into the face make-up if necessary.
Fixing Powder can be applied with a Grimas Velour Powder Puff, a Powder Puff or a Powder Rouge Brush. Gently tap the puff or brush on the back of the hand and then apply plentifully on top of the make-up. Allow to settle in and remove the excess powder with a Powder-Rouge Brush.
Detach the adhesive edge with a cotton bud soaked in Grimas Mastix Remover. Remove the adhesive and make-up residues with Mastix Remover. Massage Grimas Multi Remover Pure or Cleansing Cream into the skin and remove with a tissue. Cleanse the skin afterwards with cleansing lotion.
