Finishing off the edges

Note: you finish the edges using cotton buds with acetone. You need 15 to 20 cotton buds for this, because the acetone dissolves the plastic. Don't dip used cotton buds back in the acetone.

Take a cotton bud with acetone and make a small hole on the forehead, in the middle of the adhesive edge.
Cut vertically up to the hole. You start working from this hole with acetone to create a clean transition from the Bald Cap to the skin.
You proceed as follows: you rub the tip of a cotton bud dipped in acetone horizontally a number of times over the middle of the adhesive edge and then melt it downwards in a vertical motion.

Note: do a little piece at a time, and stay in the middle of the adhesive edge so that you are following the shape of the adhesive edge.

Make a small hole at the middle of the adhesive edge at the back as well; cut up to it and then proceed in the same fashion from the back of the head towards the back of the ears.