Grimas | Devil

ATTACHING THE GOATEE

Use Grimas Mastix Extra to attach the oblique pieces step by step. Apply glue to the part of the skin concerned and press the cut surface/obliquely cut side into the adhesive.

Attaching sequence: you attach piece 1 just under the chin, with the point forwards.

MASTIX EXTRA = Mastix Extra

If necessary, piece 2 can be made smaller by pulling off a piece from the cut surface towards the hairs.
You attach piece 2 to the chin, in the opposite direction to that of piece 1: the point points downwards in the direction of piece 1.

You attach pieces 3 and 4 close up on the left and right sides of pieces 1 and 2, the points pointing out in the same direction, namely forwards.

REMOVING THE PRODUCTS

Wool Crepe that has been stuck on with Mastix Extra you remove with Mastix Remover. You can then already pull some of the hairs loose and remove them with a tissue. The remaining hairs and the adhesive you remove with a cotton wool pad and Mastix Remover. Dab it carefully onto the skin and roll the residual material off the skin.

Removing a latex application: wipe a cotton bud soaked in Grimas Mastix Remover along the adhesive edge to loosen it. Remove the adhesive and make-up residues from the latex prostetic with Mastix Remover.

Massage Grimas Multi Remover Pure or Cleansing Cream into the skin and remove with a tissue. Cleanse the skin afterwards with cleansing lotion.

> Devil